Ford Pinto OHC Engine Intake/Inlet Manifold Dellorto DRLA 40/Weber IDF 40 Carbs

  

Ford Pinto OHC Engine Intake/Inlet Manifold Dellorto DRLA 40/Weber IDF 40 Carbs. Ford Pinto OHC engine inlet manifold for twin DellOrto DRLA 40 or Weber IDF 40 Carburettors x2. Suitable for all engine sizes 1.6, 1.8 & 2.0L. Will adapt your engine to run on a pair of down-draught webers or dellortos. Please Note: Carbs may need modification to fit.

This is a original RS2000 re-production which was designed to run on special IDF webers. These webers had narrower spindles and specific throttle linkage layout.

Today's WEBER IDF (genuine WEBER IDF) are supplied with standard spindles and throttle levers, which means they wont fit out of the box on this manifold. Spindles and spindle nuts will need to be cut/sliced short on their ends to allow fitment. Also there is no throttle linkage kit available to give you ease of installation. This is a DIY project only. Unless you have the original, factory RS2000 Carburettors and the original linkage, you will need considerable DIY skills to incorporate this manifold and standard IDF/DRLA Carburettors into your motor. Carburettor bore size 40mm Engine port size 36.5mm 21.5mm gap between the two carburettor mounts. The item "Ford Pinto OHC Engine Intake/Inlet Manifold Dellorto DRLA 40/Weber IDF 40 Carbs" is in sale since Friday, December 01, 2017. This item is in the category "Vehicle Parts & Accessories\Car Parts\Air Intake & Fuel Delivery\Carburettors & Parts".

The seller is "classiccarbs" and is located in B70 6TP. This item can be shipped worldwide.

1. Manufacturer Part Number: MPINTOTWINIDF40
2. Unit Quantity: 1
3. Brand: Alloy
4. MPN: MPINTOTWINIDF40